FLASH DRY ™ SS PET X Series FDSS PET BIO X Series

• As a biomass ink containing 10% or more of biomass raw materials in dry weight, we have obtained the Biomass Mark (registration number: 210130) certified by the Japan Organic Resources Association.
• Excellent reproducibility of gauze omissions, fine letters, and fine lines during high-speed printing.

• FDSS water resistance additive――――Adhesion/ water-based improver
• FDSS PET BIO X Viscosity Modifier ――――― Resistor
• TU262FDSS thickener --- Viscosity modifier
• FDSS compound CBS――――Curing improver
• Improved defoaming performance ――――― 900 defoamer
• SS Plate Cleaner ECO Series------A plate cleaning agent for screen printing that does not fall under organic regulations or the PRTR law. SD is the standard type, and QD is even faster drying.

* When using various additives other than FDSS PET BIO X resistors (adhesion improvers, thickeners, defoamers, curing accelerators, etc.), the upper limit should be 108% (the total amount of various additives is up to 80g per 1 kg of ink).
Please note that the biomass content of the dry weight must be observed.

• water-based
  If the following requirements are met, please add 3% of "FDSS water resistance additive". If too little is added, sufficient water-based will not be obtained, and if too much is added, curing will be poor, so please be sure to follow the additive amount.
  1) When it is difficult to maintain and manage the appropriate degree of frame treatment (balance of adhesion and water-based).
  2) When the product is used in a high temperature and high humidity atmosphere (bathroom, kitchen, etc.).
  3) If a pasteurizer (hot pack, hot shower wash, etc.) is used during the filling process.
  4) When high content resistance is required.
  Please note that the usable time after adding the additive is approximately 12 hours at room temperature, so please add the required amount to the ink.
  This product gradually reacts with moisture in the air, so close it tightly after use and store it in a cool, dark place.
• Viscosity adjustment
  * Appropriate amount of adjuvant
  ・FDSS PET BIO X Resistor: 3~10% added to ink
  ・TU262FDSS thickener: 0.5~1% added to ink
  1) Temperature change
  UV-curable inks has a high temperature dependence of viscosity, and especially at low temperatures, the viscosity (or tack) increases and the transferability of the ink decreases, so adjust the viscosity with the FDSS PET BIO resistor. Also, if thin lines, character thickness, or plate sagging occur, adjust with a TU262FDSS thickener.
  2) Printing speed
  The faster the printing, the lower the viscosity (tack) and the easier it is to transfer.
  As in 1) above, add a resistor or the like according to the metastasis state.
• storage
  It polymerizes (gels) when exposed to ultraviolet light or heat, so please store it in a closed container in a cool, dark place with good ventilation (below 25℃).
• Adhesion between overprints
  If the second color is printed after the first color underprint ink has been cured excessively, the adhesion between the inks may be insufficient. In that case, please adjust the UV lamp output to adjust the degree of curing of the underprint ink.

1. This document is an example of our test data, and the properties obtained will vary depending on printing/processing conditions, base materials, etc., and are not guaranteed.
   Before using the product, please carefully check its intended use.
2. Before handling this product, be sure to read the "Product Safety Data Sheet" and handle with care.
3. If you wish to export this product overseas, please be sure to check with us.